Maintenance; Lighting Instructions; Burner Cover Assembly; Control Knob - Costco Agio 1500096 Mode D'emploi

The flames should look like those in Figure 9. To clean the burner,
use a soft brush after the burner has cooled completely. Never use a
vacuum cleaner on the burner. It is recommended to store the fire pit
indoors during winter if it will be subjected to freezing temperatures.
The LP cylinder must be disconnected and removed from the
appliance before the appliance can be stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
1. Read instructions before lighting.
2. Push and turn the knob to ON.
3. Hold ignitor to light the burner, release control knob after 15 seconds; if burner does not
light , wait 5 minutes ,repeat.
4. Adjust flame to desired flame with the control knob. See Figure 10.
Place the burner cover on the table top as shown in Figure11.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE
THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.

MAINTENANCE

LIGHTING INSTRUCTIONS

BURNER COVER ASSEMBLY

Figure 10
Figure 11
10
Figure 9

CONTROL KNOB