V
W
X
Y
Z
AA
1.Carefully unpack all items from the box. Place the base in the final position. There must be a
minimum of 60.96 cm / 24 inches of clearance from the side of the table top to any
combustible walls.
2. Place the table top upside down on a flat, non-abrasive surface. Attach the firepit base
frame to the table top by using four 1/4"x20 mm bolts(P) and Ø20xØ6.5x2.0 mm washers(S)
as shown in Figure 3. Guide the bolts through the holes in the base frame into the pre-drilled
holes in the table top. Hand tighten only 2-3 turns.
3. Attach a firepit table leg to the table top with base by using four 1/4"x35 mm bolts(Q), two
Ø20xØ6.5x2.0 mm washers(R) and Ø6.5x1.0 mm washers(S) as shown in Figure 4. Guide
the bolts through the holes in the side leg into the pre-drilled holes in the table top with base.
Hand tighten only 2-3 turns. Repeat for the other side leg.
FIREPIT TABLE TOP
FIREPIT BASE
FIREPIT TABLE LEG
BURNER PAN PROTECTIVE
RING
BURNER COVER
FIREPAN/BURNER
ASSEMBLY
INSTALLATION
6
FP2286
1
FP2287
1
FP2288
2
FP2289
1
FP2290
1
FP2291
1
Figure 3