Maintenance And Care - Lukas e3 Manuel D'utilisation

5.6 Warning light for electronics temperature (Figure M; No. 6)
The device independently monitors the temperature of the electronics and emits a
warning if the temperature reaches a critical range. In case of increased electronics
temperature, no more turbo mode is available.
Furthermore, the device monitors the battery temperature, and with a cell tem-
perature of less than -10° C, it reduces the speed in order to warm up the battery.
As soon as the battery is warm enough, all functions are available again at normal
speed.
5.7 Illuminated direction indicator (Figure M; No. 7)
Depending on the direction in which the star grip is moved, the device indicates the
motion direction in the display field.

6. MAINTENANCE AND CARE

6.1 General maintenance
A visual check is to be carried out after each use. After every use, the lubrication of
the moving parts and bolts must be checked and topped off with a suitable grease,
if necessary. The torque of the central bolt on cutting and combination tools must
also be checked. To do so, check the specifications in the spare parts lists.
Any dirt must be removed with a damp cloth. The rescue device should not come
into contact with acids or alkalis. If this is unavoidable, clean the device immediate-
ly afterwards.
An annual inspection of the device is due each year and must be documented.
This annual inspection must be conducted by a person with the necessary exper-
tise. A function and load test must be conducted every three years or in case of any
safety concerns. Only testing equipment approved by LUKAS may be used.
Please also observe the relevant domestic and international regulations on the
maintenance intervals of rescue devices.
6.2 Maintenance after underwater use
• Remove the battery after use. Rinse the device and battery several times in
fresh, clean water. Immerse the device completely in order to fill the housing
with clean water. Lift the device out and let it drain completely. Depending on
the type of water (mud, sludge, algae, salt water, etc.) in which the device was
used, repeat these steps another 2-5 times.
• Wipe the device and the battery with a clean, dust-free and damp cloth in
order to remove dirt and deposits.
• Leave the device and battery dry at room temperature in a well-ventilated
location. 36-48 hours is recommended. During this drying time, the device is
completely operational.
• Lubricate all exposed steel parts (shear blade, pressure piece, etc.) with anti-
corrosion agent. The contacts in the battery shaft may not be lubricated.
• Perform function test.
de
en
fr
es
pt
it
nl
da
sv
fi
el
pl
cs
sk
hu
ro
bg
sl
hr
et
lv
lt
zh
ko
ja
ar
27