SPIT 250E SD Notice D'emploi Et D'entretien page 9

GB
Engine
Regularly check the power supply cable, the plug, the PRCD (2) and the switch. If any
of them are damaged, you should immediately take them to a SPIT service centre. The
carbon brushes should be replaced after 300 working hours. This too must be done at
a SPIT service centre. All these procedures, as well as a general service after 300
working hours, must be done by a SPIT service operator. SPIT cannot accept any
responsibility for apparatuses that are maintained, repaired or altered by a person or
company not recognised by SPIT.
SERVICE
Should you have any further queries, please phone one of the telephone numbers on
the last page of this manual.
SPIT takes no responsibility for machines that are not serviced, repaired or altered by a
workshop that is expressly permitted by SPIT to do so.
Dispose of your appliance, accessories and packaging in an environment-friendly
manner.
6