Sinbo SSI 2876 Mode D'emploi page 9

ENGLISH
SINBO SSI 2876 MULTIFUNCTION STEAM IRON
INSTRUCTION MANUAL
AC230V, 50Hz, 2600W
IMPORTANT SAFETY INSTRUCTIONS
When using your flatiron, basic safety precautions should always be followed, including the
following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
3. The iron should always be turned to "min",?before plugging or unplugging from outlet. Never
yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop
cord loosely around iron when storing.
5. Always disconnect iron from electrical outlet when filling with water or emptying and when
not in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To
avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified serviceman
for examination and repair. Incorrect reassembly can cause a risk of electric shock when the
iron is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not leave
iron unattended while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you
turn a steam iron upside down – there may be hot water in the reservoir.
9. If the malfunction indicator goes on, the flatiron is not operating normally. Disconnect from
the power supply and have the flatiron serviced by qualified service personnel.
10. The iron must be used and rested on a stable surface.
11. The iron is not to be used if it has been dropped, if there are visible signs of damage or if it
is leaking.
12. This appliance is not intended for use by persons (including children)with reduced physical
,sensory or mental capabilities ,or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety .
13. Children should be supervised to ensure that they do not play with appliance.
14. The iron must not be left unattended while it is connected to the supply mains;
15. The plug must be removed from the socked-outlet before the water reservoir is filled with
water;
16. When placing the iron on its stand, ensure that the surface on which the stand is placed is
stable;
17. The iron is not to be used if it has been dropped, if there are visible signs of damage or if it
is leaking.
18. If the supply cord is damaged it must be replaced by the manufacturer. its service agent or
similarly qualified persons in order to avoid a hazard.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated
- 8 -