Bosch ALB 18 LI Notice Originale page 10

10 | English
Noise/Vibration Information
Noise emission values determined according to EN 50636-2-100.
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Sound power level
– Uncertainty K
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 50636-2-100
– Vibration emission value a
h
– Uncertainty K
Assembly
Caution: Switch garden tool off and remove battery
u
from machine before adjusting or cleaning.
Mounting the nozzle (see figure B)
Slide the nozzle (4) onto the motor unit. Take care not to
pinch your fingers during assembly.
Inserting/Removing the Battery (see figure C)
Note: Using unsuitable batteries can lead to malfunctions or
damage the machine.
Insert the charged battery (5). Ensure the battery is inserted
correctly.
To remove the battery (5) from the machine, press the bat-
tery unlocking button and pull the battery out.
Switching on
Before any work on the garden product itself (e. g.
u
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
garden product. There is danger of injury when uninten-
tionally actuating the On/Off switch.
Troubleshooting
Problem Possible Cause
Machine fails to oper- Battery discharged
ate
Battery not fully connected
Battery too hot/cold
Machine defective
Garden tool functions On/Off switch defective
intermittently
Controller for airflow speed damaged
Excessive vibrations/ Machine defective
noise
F 016 L94 480 | (17.05.2022)
dB(A)
dB(A)
dB
2
m/s
2
m/s
The machine continues to blow for a few seconds after
u
being switched off. Allow the motor to stop rotating
before switching "on" again.
Do not rapidly switch off and on.
Operation
Caution: Switch garden tool off and remove battery
u
from machine before adjusting or cleaning.
Switching On and Off (see figure D)
To switch on, push the On/Off switch (1).
To switch off, release the On/Off switch (1).
Disassembling (see figure B)
Press button (3) in and remove the nozzle (4).
Working instruction (see figure E)
When operating, always hold the machine approximately
3 cm above the ground.
Do not blow hot, flammable or explosive material.
Corrective Measure
Recharge battery
Insert the battery correctly (see figure C)
Allow to cool/warm
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
3 600 HA0 3..
60
80
= 3.0
< 2.5
= 1.5
Bosch Power Tools