Turboair VIVACE Notice De Montage Et Mode D'emploi page 16

 odour filter every 160 hours.
In this case, with the hood off, when the user touches any
button the interface signals two types of needs for a period of
10'':
 if T1+T2 flash: grease filter maintenance;
 if T1+T3 flash: odour filter maintenance.
During the 10'' it is possible to reset the grease filter by
pressing T1+T2 and to reset the odour filter by pressing
T1+T3. After the reset, the button combinations will flash
rapidly twice. The interface will now work as normal.
Please note:
During the 10", the hood will work normally but without any
visual feedback regarding the speed buttons. If during the 10''
no operations are carried out, the LEDs will stop flashing and
the visual feedback will return to normal.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent. DO NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Fig. 11
Traps cooking grease particles.
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
Fig. 12
It absorbs unpleasant odors caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Circular charcoal filter
Apply one on each side as cover to both the shield grids of the
motor impeller, then turn clockwise.
For the disassembly, turn counter-clockwise.
Replacing lamps
Fig. 10
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Replace the old light bulb with the one of the same type as
specified in the feature label or near the light lamp on the
hood.
1. Using a flat head screwdriver or equivalent tool, carefully
pry loose the light cover.
2. Replace the damaged LED or halogen lamp, with one
having the same characteristics, as specified in the label
features or near the lamp:
LED lamp:For replacement, contact the technical
service.
Halogen lamp: 12V - 20W max - G4 (take care not to
touch them with your hands)
3. Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
9
CLEAN WITH TOOLS OR