Celestron StarSense Explorer DOB Guide Rapide page 3

1
A1
A2
E
1. Connect the side supports (E) to the left side panel (A1) and
right side panel (A2) using 6 of the base assembly screws (F).
The supports go on the on the same side of the panels as the
Celestron logos.
3
3. Connect the assembly to the top plate (C) using 10 of the base
assembly screws (F). Orient the top plate so the side with the
logo faces upward.
F
C
F
2
A1
F
2. Connect the side panels (A1 & A2) to the front panel (B) using
6 of the base assembly screws (F). Make sure the Celestron
logos on the side panels face outward and the small spot mark
on the face of the front panel faces inward.
4
D
G1
G2
G3
4. Attach the 3 feet (G1) to the bottom plate (D) using the 3 feet
screws (G2). Thread the screws fi rmly into the predrilled pilot
holes. Once installed, press the feet screw covers (G3) onto the
ends of the feet.
A2
B
F
Spot Mark
ENGLISH I 3