Installing The Seat On The Base; Installing The Seat With The Seat Belt - Be Cool One Mode D'emploi

EN

2. INSTALLING THE SEAT ON THE BASE

To attach the safety seat to the base, follow the steps
below:
2a. Let the baby carrier drop gently into place on the
base.
2b. Check that both sides are locked into place; the
baby carrier is correctly secured when you hear it click
into place and the part on the base of the baby carrier
(9) displays the green signal.
2c. To detach the baby carrier from the base, raise the
lever on the base (11) and pull upwards.
Turn the handle to position number 4 or 2, as
2d.
shown in diagram 2e.
26
IM 2041,00 ONE instruc ok.indd 26
3. INSTALLING THE SEAT WITH THE SEAT
BELT
To install the baby carrier without the base the car seat
belt is used as indicated below:
3a. Position the baby carrier on the vehicle seat, setting
the carry handle to position number 5 as shown in
diagram 2e. Fasten the seat belt passing it over the
carry handle.
3b. Insert the lap belt section of the seat belt through
the slots in the handle (5).
3c. The diagonal section of the vehicle seat belt should
go around the back of the baby carrier, passing the belt
through the seat belt guide (2). Tighten the vehicle seat
belt appropriately.
Get rid of any loose sections of the seat belt by pulling
the diagonal part until the seat is firmly anchored in
place.
31/1/19 16:52