SMA PPM-RC-10-BE 10 Serie Instructions D'emploi page 8

2 Safety
Danger to life due to electric shock when live components or cables are touched
High voltages are present in the conductive components or cables of the product. Touching live parts and cables
results in death or lethal injuries due to electric shock.
• Do not touch non-insulated parts or cables.
• Disconnect the product from voltage sources and make sure it cannot be reconnected before working on the
device.
• Observe all safety information on components associated with the product.
• Wear suitable personal protective equipment for all work on the product.
• Always perform all work in accordance with the locally applicable standards, directives and laws.
• Cover or isolate all live components.
Danger to life due to electric arcs if measuring device is not connected correctly
If the measurement points are incorrectly contacted, this can cause an electric arc. Electric arcs can result in death
or serious injury.
• Select the appropriate measurement range on the measuring device.
• Wear suitable personal protective equipment for all work on the device.
• Select correct measurement points.
Danger to life due to electric shock
Under fault conditions, when working on the power supply circuit there may be dangerous voltages present on the
product. This can result in death or serious injury.
• For power supply units with a fixed connection, make sure that a disconnection unit (e.g. miniature circuit
breaker) is present outside the power supply unit.
• For power supply units with a plug connection, make sure that the electrical outlet for the power supply unit is
close to the power supply unit.
• The disconnection unit and the electrical outlet for the power supply unit must be freely accessible at all times.
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or mounted.
• Transport and lift the product carefully. Take the weight of the product into account.
• Always have two persons mount and disassemble the product.
• Wear suitable personal protective equipment for all work on the product.
8 PPM-RC-10-BE-xx-10
DANGER
DANGER
WARNING
CAUTION
SMA Solar Technology AG
Operating manual