Decommissioning The Product - SMA PPM-RC-10-BE 10 Serie Instructions D'emploi

SMA Solar Technology AG

10 Decommissioning the Product

Danger to life due to electric shock when live components or cables are touched
High voltages are present in the conductive components or cables of the product. Touching live parts and cables
results in death or lethal injuries due to electric shock.
• Do not touch non-insulated parts or cables.
• Disconnect the product from voltage sources and make sure it cannot be reconnected before working on the
device.
• Observe all safety information on components associated with the product.
• Wear suitable personal protective equipment for all work on the product.
• Always perform all work in accordance with the locally applicable standards, directives and laws.
• Cover or isolate all live components.
Procedure:
1. Disconnect the product from voltage sources (see Section 7, page 25).
2. Open the product using the provided switch cabinet key.
3. Remove all connection cables from the product.
4. Lock the product using the switch cabinet key.
5. Remove the screws of the wall mounting brackets. When doing so, the product must be supported by 2 people.
6. Remove the product from the wall.
7. Remove the wall mounting brackets.
8. Dispose of the product in accordance with the locally applicable disposal regulations for electronic waste.
Operating manual
DANGER
10 Decommissioning the Product
PPM-RC-10-BE-xx-10 31