Safety Information; Installation - AquaScape AquAFORCE 1000 Mode D'emploi

Safety information

WARNING: Risk of electric shock – This pump
has not been approved for use in swimming
pool or marine areas.
WARNING: To provide continued protection
against risk of electric shock, connect to properly
grounded, ground fault circuit interrupter (GFCI)
outlets only, using the following guidelines:
(A) Have a qualified electrician install a properly
grounded receptacle outlet, acceptable for outdoor
use and protected from snow and rain.
(b) inspect cord before using.
(C) Do not use extension cords.
(D) Any wiring of pumps should be performed by a
qualified electrician to ensure code compliance
and user safety.
(e) Unplug pump at receptacle outlet when not
in use or before removal from pond.

inStallation

• Always operate the pump fully submerged. Failure to do so
will overheat the pump and cause it to fail, thus voiding the
warranty. Do Not operAte Dry!
• Use only in fully assembled state, and be sure that both
the upper and lower cage screens are snapped together.
failure to operate the pump without the filter cage closed
will allow large debris to enter the pump, causing the pump
to fail and voiding the warranty.
• Do not wear loose clothing that may become entangled in
the impeller or other moving parts.
• Keep clear of suction and discharge openings. DO NOT
insert fingers in pump with power connected.
• Do not pump hazardous materials or liquids, such as oil,
saltwater or organic solvents.
• Do not block or restrict discharge.
• Products returned must be cleaned, sanitized, or
decontaminated, as necessary prior to shipment so as
poND SqUAD
iNStAllAtioN
iNStrUCtioNS
4
(f) to reduce risk of electrical shock, all wiring
and junction connections should be made per local
codes. requirements may vary depending on usage
and location.
(g) the power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(H) Never handle power cords with wet hands.
(i) Do not remove cord and strain relief. Do not connect
conduit to pump.
(J) Do not use power cable to lift pump.
to ensure that employees will not be exposed to health
hazards in handling said material. All applicable laws and
regulations shall apply.
ImPORtANt: Aquascape, Inc. is not responsible
for losses, injury, or death resulting from a failure
to observe these safety precautions, misuse or
abuse of pumps or equipment.
aquaforCe
• Input Voltage: 120V AC
• Input Frequency: 60 Hz
• Submersible pump
• For outdoor or indoor use
• Thermally protected
• This pump has been evaluated for use with water only
• Input Amps & Wattage: See chart on next page
☎ ☎
US 1-866-877-6637 | CAN 1-866-766-3426 | www.aquascapeinc.com
SPeCifiCationS
®