Operation Instructions - Royal Sovereign Alexis 27 Guide D'utilisation

Emergency Switch (6) - To stop the machine
in a emergency situation. (Fig. 6)

6. OPERATION INSTRUCTIONS

1. Turn the laminator ON (I) located on the rear of the machine. (Fig. 2)
2. Choose the appropriate speed (Fig.1)
3. Do not begin laminating until the blinking light is steady (approximately 8 minutes).
4. Position the item to be laminated on the feed table.
. 5 P e r s s h t e R U N b
feed the item into the machine.
6. When using PET or OPP film laminate, please use a test print first to establish correct
speed and temperature for that product. Keep a distance of 15mm between prints when
running multiple prints through the laminator.
7. Stop the laminator when all of the items have completely exited the rear of the
machine.
8. Please keep the film tension controls as loose as possible but still maintaining proper
film flow over the rollers. Tighten as needed if film has slight wrinkles over the rollers.
9. If you find the temperature level is high while laminating with some films with thin
paper on the high or middle level you can try using a lower temperature level.
Repeat the above steps until all of your lamination is complete. When lamination is
completed and the machine is not in use for an extended period of time, turn the power off.
NOTE: Stand by mode and auto power off mode
- Stand by mode: If no activity is made within 30 minutes after each use the
machine will automatically switch into stand by mode. (In stand-by mode the
temperature will decrease to 80~90℃ and the three film thickness setting
indicators will blink).
- Auto power off mode: If the machine is in stand by mode and no activity is
made for 60 minutes the machine will automatically power off.
- If any activity is made while in stand by or auto power off mode the machine
will return to it's previous stage.
t u o t . n T h e o r e l l s r w l l i b e g n i o t t r u , n w i a f t
8
⑥
Figure 6
r o h e t a n i l e o t d s i a p p e a , r