Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LOADING LOWER ROLL FILM
1. Repeat steps 1-4 to load the lower roll film.
2. Once the upper and lower film is on the shaft, Make sure the both films are align
to the "O" ring.
NOTE: If the film is not aligned properly exposed adhesive will adhere to the rollers
and may cause the film to jam.
FILM THREADING
Refer to Figure 6.
2.
Do not clean rollers with sharp or pointed objects.
3.
Use adhesive remover to clean resin off of the rollers.
4.
Use a damp cloth with water to clean the body of the machine.
5.
Store machine in a dry clean area.
8. MAINTENANCE
11
Alexis 27
Publicité
Chapitres
Table des Matières
