Monogram ZMB9032 Instructions D'installation page 8

Masquer les pouces Voir aussi pour ZMB9032:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2 G CUTOUT FOR STEAM OVEN
BESIDE ANOTHER BUILT-IN STEAM
OVEN/BUILT-IN SPEEDCOOK OVEN:
25-1/4"
17-1/2" min.
17-3/4" for
Steam Oven
If you are mounting a Built-In Steam Oven beside a
Built-In SpeedCook Oven or another Built-In Steam
Oven, use the dimensions shown. The middle rail
separating the two openings may need to be larger
than the 4-1/2" minimum shown.
When installed beside a Built-In SpeedCook Oven
or another Built-In Steam Oven: Steam ovens are
suitable for installation under only certain specified
appliance models. See the label attached to the
outside of the steam oven for suitable models.
2 H FLUSHMOUNT
INSTALLATION PREPARATION
PREPARE THE INTERIOR
Cut and install side cleats:
■ Cut side wood cleats to height of cabinet opening
and approx. 2-1/2" in depth. Install, on each side,
1-1/2" from the front face of the cabinet.
Cut and install bottom cleat:
■ Cut bottom wood cleat to a height of 5/8" minimum,
a depth of the cabinet minus 1-1/2" and a width
of the cabinet opening (30") minus two side cleat
thicknesses (minimum 1/2" each) - 25 1/4" minimum
(29" if using 1/2" side cleats).
1" = 2.5 cm; 1' = 0.3 m
8
Installation Instructions
23-1/2"
25-1/4"
17-1/2" min.
17-3/4" for
Steam Oven
30-1/2" Min between
Centerlines of cutouts
of steam oven next to
steam oven/speedcook
oven
4-1/2" Min.
(5-1/2" Recommended)
2 H FLUSHMOUNT
INSTALLATION PREPARATION
(Cont.)
Install onto the cabinet floor between the side
cleats, push it all the way back against cabinet
wall and make sure its front face aligns with the
front faces of the side cleats (E gap from the front
cabinet face).
A
B
A
Side cleats depth
B
Bottom cleat height
C
Bottom cleat depth
D
Bottom cleat width
E
All three cleats inset
from cabinet front
C
A
Front Face of Cabinet
E
1/2" min
25-1/4" min
18-3/4"
5/8" min
Front View
A
C
D
E
2-1/2" min.
5/8"
Cabinet depth minus E
25-1/4"
ZMB9032: 1 7/16"
ZMB9031: 1 3/8"
D
TOP
VIEW
A
E
1/2" min
30"
31-2000693 Rev. 3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zmb9031

Table des Matières