MATERIALS YOU MAY NEED
Junction Box
Wire Nuts
Strain Relief Clamp for 1/2" Conduit
36" (91 cm) of String
TOOLS YOU MAY NEED
1/8" Drill Bit and Electric or Hand Drill
Phillips Screwdriver
Wire Strippers
1 REMOVE PACKAGING
MATERIALS AND PARTS
Failure to remove packaging materials could result in
damage to the appliance. Remove all packing parts
from oven, racks and heating elements. Remove
protective film and labels on the outer door and control
panel. Open oven door and remove literature pack
and reservoir, cookware, meat probe, and oven racks.
Locate parts package containing mounting screws.
4 Mounting Washers
4 Mounting Screws
Solid Pan
Oven Rack
Table Rack
31-2000693 Rev. 3
Installation Instructions
Perforated Pan
with Lid
Reservoir with
Inlet Tube
Small Pans with Lids
(Set of 6)
DESIGN INFORMATION
STEAM OVEN INSTALLATIONS
The steam oven may be installed in a cabinet alone
or above a warming drawer, single wall oven, or
below another steam oven or speedcook oven. The
steam oven may also be installed side by side, below
a countertop, or below specified cooktops. See the
label on the outside of the oven for approved models.
IMPORTANT: Always refer to individual installation
instructions packed with each product for specific
requirements.
2 PREPARE THE OPENING
NOTE: If the cabinet does not have a solid bottom,
two braces or runners must be installed to support the
weight of the oven. For steam ovens, the runners and
braces must support 170 lbs (78 kg).
NOTE: If marks, blemishes or the cutout opening are
visible above the installed oven, it may be necessary
to add wood shims under the runners until the marks
or opening are covered.
NOTE: If the cabinet does not have a front frame and
the sides are less than ¾" (1.9 cm) thick, shim both
sides equally to establish the cutout width.
or Equivalent Runners Level
and Flush with Sides of Cutout
Suitable
Bracing
to Support
Runners
2" x 4" (5 cm x 10 cm)
with Bottom of Cutout
C
L
1" = 2.5 cm; 1' = 0.3 m
3