2 E CUTOUT FOR STEAM OVEN
OVER A WALL OVEN AND
WARMING DRAWER
30"
17-3/4"
(17-1/2 min)
1-3/4"
(4.4 cm)
Min.
Per Oven
Requirement
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct
the required interior depth and height. See Warming
Drawer installation instructions for details.
When installed over a wall oven or warming
drawer: Steam ovens are suitable for installation
above only certain specified appliance models. See
the label attached to the outside of the steam oven for
suitable models.
CAUTION
For personal safety, the
mounting surface must be capable of supporting the
cabinet load, in addition to the added weight of this
approximate 120-pound oven, plus additional oven
loads of up to 50 pounds or a total weight of 180
pounds.
1" = 2.5 cm; 1' = 0.3 m
31-2000693 Rev. 3
Installation Instructions
Construct
Solid Bottom
Min. 3/8"
23-1/2"
Plywood
Supported
by 2x4 or
2x2 Runners
All Four
Sides
25-1/4"
24" Min between
Centerline of
cutouts of steam
oven over wall oven
2" Min.
Per warming drawer
requirement
2 F CUTOUT FOR STEAM OVEN
UNDER ANOTHER BUILT-IN STEAM
OVEN/ BUILT-IN SPEEDCOOK OVEN
30"
25-1/4"
17-1/2"
17-3/4" for Steam Oven
1-3/4"
(4.4 cm)
Min.
17-3/4"
(17-1/2 min)
If you are mounting a Built-In Steam Oven under a
■
Built-In SpeedCook Oven or another Built-In Steam
Oven, use the dimensions shown. The middle rail
separating the two openings may need to be larger
than the 1-3/4" minimum shown.
When installed under a Built-In SpeedCook Oven
or another Built-In Steam Oven: Steam ovens are
suitable for installation under only certain specified
appliance models. See the label attached to the
outside of the steam oven for suitable models.
23-1/2"
Construct solid
bottom - Min. 3/8"
plywood supported
on all four sides.
Must be able to
support weight of
oven and contents.
SpeedCook or
Steam Oven
18 5/8 Min between
centerline of cutouts
of steam oven under
steam oven or
speedcook oven
Steam Oven
7