Publicité
Les langues disponibles
Les langues disponibles
NOTE: Two adults are recommended for the Yard Guard installation.
1. Put together Yard Guard bracket as shown. Using Bolt (#66), Washer (#67), Tube (#76), another Washer (#67) Back
Bracket (#68), Washer (#67), Pivot Tube (#71) Washer (#67) and Nut (#75). Tighten Nut secure so that the rods can
pivot up and down, but front to back wobble is eliminated. See Detail 1.
2. Slide Right Yard Guard net (#73 with Goaliath Decal) onto Steel Tube (#76) as shown in Detail 2. Repeat for Left Yard
Guard Net (#72 with warning Label).
NOTE: Make sure Warning Label and artwork on Yard Guard Nets face the FRONT of pole.
NOTE: DO NOT install pole pad until instructed to do so.
Figure 17
INSTALLING THE YARD GUARD
Rubber part
goes on the
inside facing
the Pole
Detail 1
Detail 2
F R
O N
O F
T
P O
L E
76
F R
O N
O F
T
P O
L E
16
75
71
76
73
NOTE: Make sure
Warning Label and
artwork face FRONT.
Publicité
