Publicité
Les langues disponibles
Les langues disponibles
Screw #77
Detail A
23
77
77
18. Mount Goal Assembly (#28) to Backboard, as shown in
Figure 13, using four bolts (#49), four washers (#26),
and four locknuts (#4). Tighten fasteners, but leave them
loose enough to level rim.
19. Place a level across rim assembly and adjust rim until it is
level. Finish tightening the four nuts.
NEVER USE RIM WITH COVER PLATE REMOVED!
20. Attach Rim Cover Plate (#32) using four screws (#33). See
Figure 13.
21. Check all nuts and bolts and make sure everything is
tightened properly.DO NOT over tighten pivot points,
snug is tight enough.
22. Use the Backboard Pads (#44) and (#45) as a template and
mark the hole locations on the backboard frame. See Figure
13 and Detail A.
Note: Screws (#77), used in step 24, are Self Drilling
screws and can be installed without drilling pilot holes.
However, it will be easier to install screws if you drill
9/64" pilot holes. WEAR SAFETY GLASSES if drilling holes.
23. Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of
backboard tube frame.
Note: Cordless drill recommended for screw installation.
Do not over tighten screws causing screws to strip.
Note: To install screws, it will be easier if you use a
cordless drill with 5/16" socket (instead of Phillips head).
24. Secure Backboard Pads (#44) and (#45), as shown, using
screws (#77). Note: Tighten screws tight but, do not over
tighten.
13
Figure 13
77
Publicité
