Publicité
Les langues disponibles
Les langues disponibles
11.
Locate hardware needed to mount pole to anchor bolts. You will need, eight flat washers
(#37), four lock washers (#36), four hex nuts (#35) and four thread protectors (#34).
NOTE: Do not remove the nuts #35 you installed in step 2 (pg. 5).
PLACING THE POST ON THE ANCHOR SYSTEM
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
POLE WILL WANT TO LEAN WHILE ATTEMPTING TO
STAND IT UP ON ANCHOR BOLTS.
12.
Put a flat washer (#37) on each anchor bolt. Lift post onto anchor system and secure with one flatwasher (#37), one
lock washer (#36) and one hex nut (#35) for each anchor bolt. Tighten Fasteners finger tight, leave loose enough
to level pole. Place a level on pole and adjust bottom nuts #35 until pole is level (left to right and front to back).
Tighten top four hex nuts #35 tight. Place a thread protector (#34) on each anchor bolt. See Figure 10.
13.
Push on Thread Cap (#34) until it is securely in place. Cap may be tight, push hard but DO NOT hit with a
hammer! See Figure 10 and Detail A.
BE SURE CONCRETE
HAS BEEN ALLOWED
TO CURE FOR AT
LEAST 3 DAYS
Figure 10
DETAIL A
If basketball system needs to be
moved, do not try to salvage
caps. Caps (#34) will be tight,
please remove with plyers and
discard. New caps will come in
new anchor system.
If (#34) caps are missing for any
reason please call customer service.
Bottom nuts #35 can be used for
leveling system. See Step 12.
11
NOTE:
NOTE:
NOTE:
Publicité
