Adjustment Of Brake; Folding Instructions; How To Fold/ Tips For Folding - Mando footloose Manuel

Mando Footloose user manual
How to use the
product properly

Adjustment of brake

1. How to use the brake
1) Right lever = rear brake 2) For stable use, it is recommended to use the
throttle with your thumb, grab the brake lever
with your forefinger and middle finger, and use
the rest of the fingers to grab the grip.
2. How to adjust the brake reach
1) Use a 2mm hex wrench to adjust the 2) Initial position
brake reach.
3. How to replace the pad
BB7 and BB5 Installation & Set-Up Guide
A pad should be replaced when its total thickness is less than 3 mm.
How to remove the old pad
①
PAD REPLACEMENT (BB5 ONLY) Back the inner adjustment knob all the way out (counterclockwise). Pull the pad spreader clip from
A pad should be replaced when its total thickness (backing plate and friction material) is less than 3mm.
between the pads, then pull the pads out of the caliper one at a time.
1. REMOVE THE OLD PADS
Back the inner adjustment knob all the way out (counterclockwise). Pull the pad spreader clip from between the pads, then pull Install a new pad and spring
②
the pads out of the caliper one at a time.
Insert the new pads one at a time into the caliper.
2. INSTALL THE NEW PADS AND SPREADER
Insert the new pads one at a time into the caliper.
Make sure to place the black pad on the inner side (towards the wheel), and blue pad on the
V : M ( )
ERY IMPORTANT AKE SURE YOU PLACE THE BLACK PAD ON THE INNER SIDE TOWARDS THE WHEEL AND THE BLUE PAD ON THE OUTSIDE
outer side (away from the wheel).
( .) O
AWAY FROM THE WHEEL NCE THE PADS ARE IN THE CALIPER YOU CAN SLIDE THE SPREADER CLIP BACK INTO POSITION
Once the pad is installed on the caliper, slide the pad spreader clip back to its initial position
(between the pads).
Pad spreader
Black pad "Left"
Pad
A detailed picture about the pad
spreader clip
Blue pad "Right"
SRAM C o p r o a r o i t n u J y l 2 0 0 5
C-3
3) Left lever = front brake, use the same
method
3) The brake reach has been adjusted
(adjust the brake reach according to the
length of your fingers)
English
– .
BETWEEN THE PADS
13
08
A new way of moving

Folding instructions

How to fold/ tips for folding

Mando Footloose is designed to be foldable so the volume of the product can
be reduced to allow easier storage and transport. Folding can be done by
operating the folding lever located in the center.
1. How to fold Mando Footloose
OFF
1) Ensure that the power is off.
4) When the handlepost clamp is lifted,
the whole handlepost can be folded
backward to its left side.
7) Hold the position of rear wheel with
your right foot against the tire so Mando
Footloose does not move during folding,
and fold Mando Footloose by lifting the
seat or centre frame up.
2. Unfolding Mando Footloose:
Tips for folding / unfolding
① Ensure that the power is off before folding / unfolding.
② Do not turn the power on during folding.
③ After unfolding, lock the folding lever so it is closed properly. If the folding lever is not fixed completely, it may
cause a problem during a ride.
2) It is recommended to stand on the left 3) To fold the handlepost, loosen the
side of Mando Footloose with the front handlepost clamp folding lever and lift
wheel heading forward. the whole clamp upward.
5) Check that the right pedal is forward the 6) Unlock the folding lever located in the
cranks horizontal (incorrectly aligned center frame by pulling it up (hold the
pedals may damage the frame). upper part of the front frame with your
left hand and lift the folding lever with
your right hand).
8) Hold the seat or frame with your left 9) Roll Mando Footloose by holding the seat.
hand and push down the folding lever to
the 'fixed position' with your right hand.
Reverse the steps above.
English
09
D