Kübler HW66 Instructions De Service Et De Montage page 4

Mounting and Operating Instructions
Energy and time meters
HW66 and HW66M
4319 5065 0 R.600.703 01.2008
1.1 Safety instructions and warnings
Only use this display
– in a way according to its intended
purpose
!
– if its technical condition is perfect
– adhering to the operating
instructions and the general
safety instructions.
1.2 General safety instructions
Observe the nominal voltage before operating
the device, see type plate. Make sure that the
connection lines are not damaged and that
they are disconnected while wiring the device.
Cleaning:
With power disconnected, the meter can be
cleaned with a dry cloth or a cloth moistened
with soap solution. Under no circumstances
must corrosive or solvent-containing sub-
stances be used for cleaning.
Maintenance:
The HW66 is maintenance-free. In case of
damages caused by transport or storage the
operator is not allowed to carry out repairs.
Guarantee:
Opening the meter will void any warranty
claim. In addition, the calibration of calibrated
measuring devices will become invalid.
1.3 Designated use
The local standards, guidelines, directives and
regulations must be observed. The installation
of the meter must be carried out by expert and
trained personnel only. Protect the meter
against humidity when storing and transpor-
ting it and do not operate it outside of the spe-
cified technical data.
Sealing:
The meter is not equipped with a lockable
cover, thus there is no possibility of sealing.
To meet the requirements according to EN 50
470 - 1, art. 5.5, in case of an accounting
device, the housing that contains the meter
must be sealable.
4
1.
3.
1.) Operating hours display
2.) LED operation control
3.) Energy consumption dislpay
1.4 Description:
The double display of kWh and time has
been especially developed for making the
accounting of rental devices and machines
exact and reproducible. The meters of the
HW 66 series are tamper-proof and show
both values even with power disconnected.
The kWh display of the MID counter HW66M
is factory-calibrated and may be used for
accounting purposes
2. EC Declaration of Conformity
HW66 and HW66M
• EN 50470 Parts 1 and 3 (electronic meters),
October 2006
Only HW66M
• Directive 2004/22/EC of the European
Parliament and the Council on Measuring
Instruments
• Appendix I, Basic requirements
• Appendix MI-003, electricity meter for the watt-
hour consumption
Year of issue of the EC Declaration of
Conformity, see print on the device.
Example: Declaration of Conformity for 2007
CE M07
2.
1259