Ega Master CURVAMATIC-3 Manuel D'instructions page 10

B) BENDING OF PIPES
B1- The upper screw for oil filling must be half-opened for use. It only must be completely closed
for transport.
B2- Close the valve (nº50).
B3- With the superior plate withdrawn, place both resting forms in their corresponding housings of
the interior plate according to the size of the pipe bent.
B4- Select the form corresponding to the resting form in the end of the piston.
B5- Place the corresponding form in the end of the piston.
B6- Insert the pipe to be bent, housing it between the form and the resting forms.
B7- Insert and actuate the bar, inside the housing of the big piston (left) and we will actuate it fast
untill the pipe contacts with the bending form. At this moment smooth-bending speed will
start, which enables bending with minimal effort.
B8- Once the bend is gotten, the (nº50) will be oppened and by making this action, the piston will
go back automatically.
B9- Raise the superior plate and withdraw the form together with the bent pipe, removing it from the same.
B1
B4
B7
10
B2
nº50
B5
B8
nº50
B3
B6
B9