Cleaning; Storage; Troubleshooting - MAXXMEE Smoothie Maker 2 go Mode D'emploi

Masquer les pouces Voir aussi pour Smoothie Maker 2 go:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Smoothie Maker 2 go
on the motor unit. The blade (9) starts
to rotate.
5. Turn over the product and place the
motor unit on a fl at, even surface. If
necessary, move the product to the left
and right slightly to make the blending
process even better.
After approx. 25 seconds, the
motor unit switches off automati-
cally to prevent overheating. Allow
the motor unit to cool down for a
little while before it is switched on
again. The operating lamp fl ashes
red if it is not yet ready to operate
again.
6. Turn the product over again so that
the motor unit is at the top.
7. Unscrew the motor unit anticlockwise
and enjoy the smoothie.
8. Clean the product after each use to
prevent the formation of germs (see
the "Cleaning" chapter).

CLEANING

Please Note!
The motor unit is not dishwasher-safe.
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the product. These may damage
the surfaces.
Wipe down the motor unit (4) with
a damp cloth. If necessary, use a
little mild detergent to remove more
intense soiling.
The blade (9) may be rinsed under
running water, but when you do this
make sure that no water gets into the
top of the motor unit.
Clean the cup (8) with the silicone
sleeve with warm water and mild
detergent or in the dishwasher.
02757_inlay_DE-EN-FR-NL_A5_V1.indb 11
02757_inlay_DE-EN-FR-NL_A5_V1.indb 11
Allow all parts to dry completely be-
fore storing them away.

STORAGE

Thoroughly clean the product (see the
"Cleaning" chapter) to avoid possible
mould formation.
Check the USB cable for damage
regularly.
Store the product and all accessories
in a dry, clean, frost-free place at tem-
peratures of 0 – 40°C that is protected
from direct sunlight and cannot be
accessed by children or animals.

TROUBLESHOOTING

If the product does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an electri-
cal product yourself!
The motor unit (4) cannot be
switched on.
The battery is empty.
► Charge up the battery.
The motor unit is not fi tted correctly on
the cup (8).
► The operating lamp (1) must be lit
green so that the motor unit can be
switched on.
The fruit or vegetables are blocking the
blade (9).
► Take the motor unit off again and
carefully remove the blockage.
EN
11
18.06.2020 11:53:34
18.06.2020 11:53:34

Publicité

Table des Matières

Dépannage

loading

Table des Matières