Cleaning And Storage - MAXXMEE WCP-06 Mode D'emploi

EN
5. Fully unwind the connecting cable
and plug the mains plug into a plug
socket.
Chopping Up Food
Please Note!
■
For safety reasons, the device can
only be switched on if all accesso-
ries are fitted correctly and the lid is
locked on.
■
Never fill the mixing container with
hot food or liquids! The contents must
not be hotter than 50°C. There is a
danger of burns.
■
Do not overfill the device! Do not
exceed the maximum fill level (MAX
markings on the mixing container).
■
Do not move the device during oper-
ation. Always remove the mains plug
from the plug socket before transport-
ing the device.
■
Use the device for no more than
15 seconds without interruption to
prevent overloading. Allow the device
to cool down before using it again.
L
For good results, hard foodstuffs
should not be processed in large
pieces. If necessary, chop them
into cubes approx. 3 cm in size
beforehand.
1. Place food in the mixing container.
2. Attach the lid (1) to the mixing con-
tainer.
3. First switch on the device on a low
setting 1: Twist the switch (7) to the 1
position and then press the Start
button (5).
The blade insert starts to move.
4. If necessary, increase the speed by
turning the switch to position 2.
L
Liquid ingredients can be added
through the filler opening (10)
during operation.
14
After Chopping
1. To switch off the device, let go of the
Start button and move the switch to
the 0 position.
2. Wait until the blade insert has come
to a standstill. Only then should you
take off the lid.
3. Carefully take out the blade insert.
4. Remove the mixing container from the
motor unit.
5. Remove the mains plug from the plug
socket after use.
6. Clean the used accessory after every
use to prevent the formation of
germs. Do not allow any food resi-
dues to dry on (see the "Cleaning and
Storage" chapter).

CLEANING AND STORAGE

Please Note!
■
Do not use any corrosive or abrasive
cleaning agents or scouring sponges
to clean the device. They may dam-
age the surface.
1. Do not immerse the motor unit (4)
in water or other liquids! Do not
place in the dishwasher! Wipe down
with a damp cloth if necessary.
2. Clean all other accessories with de-
tergent and warm water. The mixing
container (3) can be also cleaned in
the dishwasher.
3. Allow all parts to dry completely or
dry them with a tea towel before they
are assembled or stored away.
4. Store in a cool and dry place out of
the reach of children and animals.
L
Some types of fruit and vegeta-
bles (e.g beetroot) may stain the
plastic parts. This is harmless and
does not constitute grounds for
warranty claims.