Faults And Troubleshooting - Comedes Lavaero 1200 Mode D'emploi

Faults and troubleshooting

Current operating instructions can be found at http://www.comedes.com
Turn off the unit immediately and contact your dealer if any of the following problems occur:
Fuse's blown.
•
Foreign material gets into the device.
•
The plug or power cord heats up.
•
Do not open the unit without authorized service personnel. However, you can check the
following causes of faults yourself:
The device cannot be switched on:
Is the plug inserted correctly?
•
Has the fuse blown or is there no voltage at the socket?
•
Isn't the device upright or has it been put down?
•
Is the filter cover fitted correctly?
•
The air flow at the outlet opening is lower:
Is the filter too dirty or clogged?
•
The air quality is always very good, even though the air is polluted:
Has the unit been positioned in a narrow niche or similar?
•
Can sufficient air circulation build up in the room?
•
Poor air quality is always displayed even though the unit has been running for a long
time:
Is the particle sensor dirty?
•
The air purifier emits an unusual odor:
Are the filters too dirty or clogged?
•
The air purifier does not automatically switch to sleep mode:
Is automatic mode activated?
•
The device is disproportionately loud:
Does the device stand on an uneven surface?
•
Isn't the filter unpacked?
•
Is the filter too dirty or clogged?
•
Remote control does not work:
Replace the battery.
•
The filter performance is very low:
•
Are the filters inserted in the correct order?
Aren't the filters unpacked?
•
Do the filters have to be replaced?
•
EN-13 www.comedes.com