Comedes Lavaero 1200 Mode D'emploi page 25

Masquer les pouces Voir aussi pour Lavaero 1200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
turbo
Press this button to start the Turbo function. The air purifier immediately switches
to the highest fan level (6). This function is particularly suitable for use in rooms
where cigarettes are smoked. If the turbo function is active, the corresponding
key on the control panel lights up.
Press one of the two "SPEED" buttons to exit this mode.
sleep
In this mode, the device operates at the lowest fan speed for minimal noise.
Except for the Sleep display, all displays go out.
If a running time has been set via the timer before the start of the sleep
function, this setting remains and the device switches itself off after the time has
elapsed. To exit Sleep mode, press either Sleep, Turbo or one of the two Speed
buttons twice in a row.
light sensor
The air purifier is equipped with a modern light sensor. If the unit works in
automatic mode, both the air quality and the light intensity are monitored. If it is
dark in the room for longer than 3 minutes (less than 5-10lms), the device
automatically switches to sleep mode. If the room is illuminated for longer than
5 minutes (more than 10lms), the unit returns to normal automatic mode.
speed
Press the "+" key to increase the fan speed.
Press the "-" key to lower the fan speed.
The set fan level (1-5) is visualized via the bars on the display.
Child lock (Lock)
Press the "CHILD LOCK" button to activate the child lock/key lock. If the parental
control is activated, the corresponding key lights up.
Press and hold this button again for at least 5 seconds to release the key lock.
The child lock is activated by pressing the "LOCK" button on the remote control
and deactivated by simply pressing the "UNLOCK" button.
Filter change indicator and filter reset
The Comedes Lavaero 1200 has a modern filter change indicator. If the
corresponding symbol lights up, the filters must be checked/changed. After you
have changed or cleaned the filters, you can reset the display by pressing the
filter reset button.
Depending on the type and intensity of use, the filter may have to be replaced
before the filter change indicator lights up. Therefore, check the filter regularly.
EN-9
www.comedes.com

Publicité

Table des Matières
loading

Table des Matières