MAUNAWAI PIPRIME K8 Manuel De Montage Et D'utilisation page 11

1
Leave all filter modules completely
covered by water overnight.
3
Then add the solution to the liquid
in which you are going to soak
your PIPRIME cartridge.
5
Shake the filter cartridge
vigorously several times.
20
2
200 ml
5 min.
Put one tablet in a glass with
200ml of water and let it remain
for 5 minutes.
4
60
min.
Now leave the cartridge in the
solution for 60 minutes.
6
Clean all other parts with (organic)
rinsing liquid and rinse well with
clean water.
SOaK
1 Place all filter modules
· Limescale filter pad,
· ceramic filter,
· PIPRIME filter cartridge,
completely covered in tap water
overnight. Never use dishwashing
liquid for the filter modules. (Please
soak the filter cartridge separately
in a separate container).
Hold the ceramic filter under wa-
ter until the air has completely
escaped. Make sure that the filter
screw points upwards. The air can
escape through the opening in the
bottom.
2
Put the Oxosanum tab in a glass
with 200 ml water and let it remain
for 5 minutes.
3
Then add the solution to the
liquid in which you are going to
soak your PIPRIME cartridge.
4
Now leave the PIPRIME car-
tridge in the solution for the rest of
the soaking time. When inserting
the cartridge, avoid contact with
unfiltered water and unwashed
hands.
5
5. The ceramic beads in the
PIPRIME filter cartridge have a lot
of air. Therefore, soak well and
shake vigorously several times to
release any remaining trapped air.
cLEanIng
6
Except the filters, clean all other
parts of the system with an organic
rinsing fluid and rinse thoroughly
with clean water.
Do not use hot water, do not put
any parts in the dishwasher. Only
use soft cleaning cloths to avoid
scratches.
After the preparation is complete,
simply assemble your water filter
system following the steps below.
(page 22 and 23)
en
21