Assembly - MAUNAWAI PIPRIME K8 Manuel De Montage Et D'utilisation

1
Place the drinking water tank on
the base.
3
Screw the filter cartridge together
with the cartridge hanger.
(Do not tilt the thread).
5
Insert the ceramic filter in the
upper tank from the inside.
22
2
Mount the water tap with two
seals (dry) on the inside and out-
side of the tank.
4
Hang the filter cartridge in the
glass container and insert the
limescale filter pad.
6
Slide the sealing ring onto the
filter screw on the underside
and tighten the wing nut.
7
Set up the upper tank and lid.
8
Fill with tap water and let it run
through completely.
Now your source is ready for use.

aSSEMbLY

1
Place the drinking water tank on
the base.
2
Install the water tap. Each of the
two sealing rings are attached to
the inside and outside of the drink-
ing water tank. The tank should be
dry in the area of the silicone seal to
avoid leaks later on.
Screw the PIPRIME filter car-
tridge together with the cartridge
hanger. When screwing it in, make
sure that the screw thread does
not tilt. Do not apply force on the
plastic threads.
Attach the filter unit in the
drinking water tank made of glass.
Insert the limescale filter pad in the
top side of the cartridge hanger, di-
rectly over the PIPRIME cartridge.
5
Then insert the ceramic filter
in the upper tank into the opening
provided.
6
Slide the sealing ring on the un-
derside of the tank onto the filter
screw. Then screw the filter tight
with the wing nut.
7
Place the upper tank on the
drinking water tank. The lid closes
the upper tank.
8
Now fill tap water into the upper
tank and let it run through.
Now your MAUNAWAI® water sys-
tem is ready for use.
en
23