Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• 24 V AC (WV-CP284)
The recommended cable length and thickness are shown in the table for reference. The
voltage supplied to the power terminals of the camera should be within 19.5 V AC and 28 V
AC.
Power cord (not supplied)
AC 24V IN
1L
GND
n
Bundle the coaxial cable and the power cord to the camera mount bracket with cable ties
(not supplied).
Important:
• When bundling the cables with cable ties, cable ties should have enough tolerable
intensity and durability, such as a metal cable tie since a coaxial cable can support the
camera in case of falling of the camera from the camera mount bracket.
Camera mount bracket
(option)
Bundle the cables and fix
them onto the camera
mount bracket firmly.
m
Adjust the focus position.
Loosen the flange-back lock screw and rotate the flange-back adjustment ring to adjust the
focus position while monitoring the video monitor. When completing the adjustment, tighten
this screw.
Recommended tightening torque: 0.05 N·m {0.5 kgf·cm}
Important:
• When the screw is tightened stronger than the recommended tightening torque, it may
strip the thread or cause focus misalignment.
Notes:
• When using a fixed-focal lens featuring the focus adjustment, adjust the flange-back
length after setting the lens focus to the FAR end.
• When using a vari-focal lens featuring the focus adjustment, refer to the operating
instructions of the lens in use.
2N
Example: Ceiling mount
installation
Copper wire
#24
size (AWG)
(0.22 mm
Length (m)
20
Length (ft)
66
Camera mount bracket
(option)
Example: Wall mount
installation
#22
#20
2
2
)
(0.33 mm
)
(0.52 mm
30
45
100
150
Bundle the cables and fix
them onto the camera
mount bracket firmly.
#18
2
2
)
(0.83 mm
)
75
250
13
Publicité
Chapitres
Table des Matières
