Cameo STUDIO PAR 64 LED CAN CLPST64RGBWAU12W Manuel D'utilisation page 17

COLOUR BLENDING
In the colour fade mode (fading mode) different colours are blended into one another in succession. The speed of the program is adjustable
separately and a stroboscope effect can also be activated.
Press MODE repeatedly until "FADING" appears in the top line of the display. Now press ENTER and use UP and DOWN to select the speed
(SPEED) at which you want the colours to fade into each other, from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display changes to "FLASH:xx". The cursor will appear in the bottom line at the same
time and you can activate the stroboscope effect using the UP and DOWN buttons and adjust the flash frequency from 00 to 99 (FLASH:00 = strobe
deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz). Confirm with ENTER.
COLOUR BLENDING
Rate SPEED:00 - SPEED:99
AUTO MODE
Press the MODE button repeatedly until „AUTO MODE" appears on the display. In this operating mode, the light switches automatically between
colour change and colour blending mode. The colour change and/or colour blending rate is determined by the settings of the respective mode. A
stroboscopic effect cannot be activated.
WHITE BALANCE
Cross-mode brightness setting of R, G, B, W, A and UV with values ranging from 000 to 255 for individual colour calibration. Press MODE repeatedly
until "WhiteB" appears in the top line of the display. Now press ENTER repeatedly to select the colour whose brightness you wish to alter (note cursor
in display, Rxxx = red, Gxxx = green, Bxxx = blue, Wxxx = white, Axxx = amber, Uxxx = UV/black light). Now use UP and DOWN to set the intensity of
the selected colour to between 000 and 255. Confirm by pressing ENTER.
BALANCE CURV
Cross-mode brightness setting of red and green using two presets (preset "Normal" = no reduction of the maximum brightness of red and green,
preset "Lower" = reduction of the maximum brightness of red and green to adapt the colour blend to spotlights with lower maximum brightness of
red and green). Press MODE repeatedly until "BalCurve" appears in the top line of the display and press ENTER. Now use UP and DOWN to select the
desired preset, and then press ENTER to confirm.
SLAVE MODE
Press the MODE button repeatedly until „SLAVE MODE" appears on the display. Connect the slave and the master unit (same model) with a DMX
cable. Now the slave unit follows the master unit.
MUSIC CONTROL
Press the MODE button until „SOUND" appears in the upper line of the display. Now the projector is controlled by the built-in microphone and follows
the beat of the music. To adjust the microphone sensitivity, press ENTER and use the UP and DOWN buttons to set the desired value from 00 to 31
(SENS:00 = minimum sensitivity, SENS:31 = maximum sensitivity). Confirm with ENTER.
STROBOSCOPE
Flash frequency FLASH:00 - FLASH:99
17