Télécharger Imprimer la page

Vollrath JW30 Manuel D'utilisation page 3

Publicité

Les langues disponibles

Les langues disponibles

CLEANING
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
TROUBLESHOOTING
Problem
Oven does not heat.
35 Inch Cheese Melters Operator's Manual – Model JW30
Might be Caused By
Oven is not plugged in.
The timer has not been set.
The wall breaker may be tripped.
The reset may be tripped.
One or more heater tubes may have
burned out.
There may be a problem with the heat
switch.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the equipment. These can damage
the finish.
1. Press the On/Off switch to the OFF position.
2. Unplug the oven.
3. Let the oven cool completely.
4. Slightly dampen a soft cloth with a warm water.
5. Use the dampened cloth to clean the interior and exterior of the
oven, and the air intake on the side of the oven
6. Remove the shelf and clean with warm soapy water.
Course of Action
Plug in the oven.
Set the timer. The timer must be set to turn on all the heater tubes.
1. Inspect for tripped breaker.
2. Reset the breaker.
3. If the breaker was not tripped, inspect the oven for broken heater
tubes.
4. For broken tubes, contact Vollrath Technical Services.
Look on the side of the oven to see if an object is preventing the fan
blades from turning.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven to cool.
4. Remove the object.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
Inspect the fan blades to see if they are dirty.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven to cool.
4. Clean the fan blades.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
Contact Vollrath Technical Services.
3

Publicité

loading

Ce manuel est également adapté pour:

Cm4-20835Cm4-24035Cm4-23035