Checking The Function And Setting The Camera; Cleaning And Caring For The Camera; Guarantee; Disposal - Waeco PerfectView CAM33C Notice De Montage Et D'utilisation

_RV-33.book Seite 47 Donnerstag, 30. November 2006 1:41 13
PerfectView
8 Checking the function and setting the
camera
➤ Check the function of the camera after you have connected it to a monitor.
➤ Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at
the bottom edge of the screen. The middle of the bumper should be in
the middle of the screen (fig. o, page 10).
➤ Tighten the six fastening screws of the camera bracket.
Settings for contrast and brightness can be made on the monitor.
9

Cleaning and caring for the camera

Caution!
a
Do not use any sharp or hard objects for cleaning since they may
damage the device.
➤ Clean the camera with a soft, damp cloth from time to time.
10

Guarantee

The statutory warranty period applies. If the product is defective, please re-
turn it to the WAECO branch in your country (see the back of the instruction
manual for the addresses) or to your dealer. For repair and guarantee
processing, please include the following documents when you send in the
device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
11

Disposal

➤ If possible, always take the packaging material for recycling.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in keep-
ing with the applicable regulations.

Checking the function and setting the camera

47