Waeco PerfectView CAM33C Notice De Montage Et D'utilisation page 46

_RV-33.book Seite 46 Donnerstag, 30. November 2006 1:41 13
Fitting the camera
7.4 Connecting the RV-SWITCH switchbox (only
CAM33C, CAM33C1) (fig. p, page 10)
The switchbox is supplied ready for installation.
➤ Fasten the switchbox at a suitable point.
➤ Connect the switchbox electrically as follows:
– Connect camera inputs 1 and 2 on the motor to the connections "V1"
and "V2".
– Connect the camera to the "TWIN" connection.
The camera is switched on and off in reverse gear or using the camera se-
lection button on the monitor.
7.5 Connecting the RV-AMP/4 switchbox (only
CAM33C2, CAM33C3) (fig. q, page 11)
Note
I
If you would like to use both camera modules when driving for-
wards, you will need to fit the flip switch supplied (see the installa-
tion and operating manual for RV-AMP/4).
The switchbox is supplied ready for installation.
➤ Mount the switchbox as described in the corresponding installation and
operating manual.
Note
I
Output "2" on the switchbox is an auxiliary output, e.g. for connect-
ing an external monitor.
➤ Connect the switchbox electrically as described in the corresponding in-
stallation and operating manual.
46
PerfectView