Setting The Camera; Using The Lcd-Monitor; Switching On The Monitor - Waeco PerfectView LCD250 Instructions De Montage Et De Service

_RV-250.book Seite 43 Donnerstag, 14. Dezember 2006 4:54 16

Using the LCD-monitor

7.6

Setting the camera

➤
Switch the monitor and camera on.
➤
The monitor image should show the bottom edge of the rear or the bumper of your
vehicle (l A, page 11). The middle of the bumper should be in the middle of the
screen. Turn the camera in the camera holder (l B, page 11) to correctly set the
camera.
➤
When you have set the camera properly, tighten the 6 fastening bolts.
Caution!
The camera's plug connection is not protected against moisture. It is essential
that you wrap insulating tape around the connection to prevent damage.
Tip!
To minimise corrosion in the plug we recommend that you apply a small
amount of grease, e. g. pin grease into the plug.
We recommend greasing the threads of the bolts to prevent corrosion.
8 Using the LCD-monitor
8.1

Switching on the monitor

The monitor is switched on automatically, if you shift into reverse gear. The
picture from camera 1 is transmitted.
If you have connected a side camera, the monitor is switched on automatically,
if you actuate the indicator. The picture from camera 2 is transmitted.
➤If the monitor is switched off, press the "Power" switch (0 10, page 6), to
switch the monitor on.
✓
The picture appears.
✓
Depending on the camera that was switched on last, LED "C1" (0 7, page 6,
camera 1) or LED "C2" (0 8, page 6, camera 2) will be lit.
➤
Test if the mirror function (see chapter "Operating elements" on page 34) is correctly
set.
The setting should be such that an obstacle behind the vehicle on the right also
appears on the right in the monitor.
8.2 Switching off the monitor
➤ Press the main switch "Power" (0 10, page 6), to switch off the monitor.
✓
The picture disappears.
43
All manuals and user guides at all-guides.com
PerfectView LCD250