SOMFY LT 50 CSI Notice D'installation page 14

EN
1) Slide the motor into the roller tube.
For smooth roller tubes, position the notch previously cut on
the crown.
2) Fix the roller tube to the drive wheel with 4 x Ø 5 mm self-
tapping screws or 4 steel pop rivets of Ø 4.8 mm located:
- at least 5 mm from the far end of the drive wheel: L1 - 5,
and
- no more than 15 mm from the far end of the drive wheel.
N.B.: the screws or pop rivets must only be attached to the
drive wheel and not to the motor.
The motor can be supplied, optionally, with two adjustment
pull tabs. These pull tabs can be used to operate the
adjustment push-buttons when they are not accessible.
- Remove the protective housing.
- Fit the pull tabs on the motor head.
these pull tabs.
Fit the crank handle onto the motor head.
- Mount the motorised tube on the end bracket.
- Mount the motorised tube on the motor bracket.
- Switch off the power supply.
- Connect the motor according to the information in the table
below:
Blue
1
Brown
2
Black
3
Yellow/Green
4
14
White Neutral
Black Live
Red Live
Green Earth
1
2
Copyright © 2007-2016 Somfy SAS. All rights reserved.
LT 50 CSI - LT 60 CSI
L1
=
1
4
P
230 V - 50 Hz
120 V - 60 Hz
3 x 1,5 mm 2