SOMFY LT 50 CSI Notice D'installation page 13

LT 50 CSI - LT 60 CSI
This Somfy product must be installed by a professional motorisation installer, for whom these instructions
are intended.
and accessories.
These instructions describe how to install, commission and use/operate this product.
Moreover, the installer must comply with current standards and legislation in the country in which the
product is being installed, and inform his customers of the operating and maintenance conditions for the
product.
covered by the guarantee. In this event, as for all usage not consistent with the instructions given herein,
Somfy accepts no responsibility for harm or damage.
1) Never immerse the motor in liquid!
2) Avoid impacts!
3) Do not drop it!
4) Never drill holes in the motor!
5) Always make a loop in the power supply cable
to prevent water entering the motor!
-
- Never connect two control points to a single motor.
- Never connect two motors to a single control point.
- Do not use a lighting control point.
- Check that the motor has been supplied with the protective housing and, optionally, with the adjustment
pull tabs.
-
(accessories not supplied).
1) Fit the crown (A) and drive wheel (B) to the motor.
2) Measure the length (L1) between the motor head and the
end of the drive wheel.
1) Cut the roller tube to the required length.
Deburr the roller tube and remove the swarf.
2) For smooth roller tubes, cut a notch with the following
measurements:
LT 50 CSI 4 mm (0.16 in)
LT 60 CSI 25 mm (0.98 in)
Copyright © 2007-2016 Somfy SAS. All rights reserved.
e h
8 mm (0.32 in)
35 mm (1.38 in)
1 2
5
4
1
2
1
2
EN
3
B
A
L1
L1
h
e
13