Assistance With Problems; Technical Data - Intenso Memory Center Notice D'utilisation

ASSISTANCE WITH PROBLEMS

Status LED is not illuminated
Check the hard drive, the power supply and the USB cable for visible damages. If there is such a da-
mage, please turn to our Support to exchange it. Under no circumstances should you use the de-
fective device, power supply or cable. Check whether the cable connection is correctly plugged in.
Hard Drive is not recognized
Check the points under "Status LED is not lit" first.
Please check all other existing USB ports of your device. Please use only the supplied cable and in
particular no extension.
If the hard drive is not recognized at any USB port of your device, please try whether it works on
another device to exclude a possible defect.
Check the Disk Management, it may be possible that only a drive letter has to be assigned (for
more details please see the Help file of your Windows version).
If you used the hard drive before, for example, on a TV set, it may be that you need to format
the hard drive first to be able to use it on a computer again (for details please see the operating
instructions of the previously used device and/or the Help file of your operating system provider).

TECHNICAL DATA

EXTERNAL USB 3.0 HARD DRIVE 3.5" (8.9CM)
Dimensions (3.5" housing):
Transfer rate:
Capacity calculation:
118 x 119 x 34 mm
max. 5 GBit/sec (USB 3.0)
1 MB = 1,000,000 bytes/
1 GB = 1,000,000,000 bytes
EN - Page 5 of 7