Pentair Jung Pumpen EASYLOGO 2-00 E Instructions De Service page 14

ENGLISH
INSTALLATION
Note!
Do NOT install the EASYLOGO 2-00 E control unit in an explosion hazard area or in the collecting chamber.
ATTENTION!
NEVER put the mains plug in water!
Ingressing water may result in malfunctions and complete failure!
Always keep the mains plug away from the collecting chamber and from water.
High water level sensor
14
NOTE!
Only operate the control unit in dry rooms, and keep the housing closed at all times.
Optionally, the control unit can be fitted in an empty housing outside the building.
ATTENTION!
Condensation may occur if fitted in an empty housing outside the building!
May result in malfunctions and complete failure!
The empty housing must be installed in accordance with the instructions! Refer to the
installation instructions for the "Empty housing"
Empty housing
1
Sealing plug DN 100
2
2 White sand or special-purpose pedestal filler
3 Cable conduit DN 100
The "high water" level sensor attached in the factory is
installed with the guide rail system.
Alarm = High water alarm
EASYLOGO 2-00 E B 55002.11-2022.01