Troubleshooting - AL-KO Snow Line 700E Mode D'emploi

Snow Line 700E, 760TE

Troubleshooting

Caution!
Before troubleshooting, always switch off the engine and disconnect the spark plug connector.
Problem
Engine does not start.
Engine performance is diminished.
Wheel drive does not work when clutch
lever is pressed.
Wheel drive cannot be stopped
(does not disengage).
Auger does not turn when clutch lever
is pressed.
Auger drive cannot be stopped
(does not disengage).
Machine vibrates excessively.
Machine pulls to one side.
If problems are not listed in this table or you are unable rectify them yourself, please consult our
customer service department.
474911_a
Solution
▪ Add petrol.
▪ Set throttle to "Start".
▪ Open the choke, push the primer button.
▪ Check the spark plugs and replace if necessary.
▪ Clean discharge chute/housing.
▪ Remove snow and ice from auger and impeller.
▪ Reduce operating speed.
▪ Adjust control cable.
▪ Contact the customer service workshop.
▪ Switch off the engine.
▪ Do not attempt repair!
▪ Contact the customer service workshop.
▪ Shear pin is broken, replace.
▪ Adjust control cable.
▪ Contact the customer service workshop.
▪ Switch off the engine.
▪ Do not attempt repair!
▪ Contact the customer service workshop.
▪ Check auger and impeller.
▪ Check the tyre pressure and inflate.
▪ Check the skid plates; adjust or replace.
GB
35