Maintenance And Care - AL-KO Snow Line 700E Mode D'emploi

Snow Line 700E, 760TE

Maintenance and care

Danger - risk of injury!
▪ Before performing any maintenance or service,
always switch off the engine and disconnect the
spark plug connector.
▪ The engine may coast down. After switching off,
make sure that the engine is at a standstill.
„ Clean the machine after every use. Be especially
sure to remove residual de-icing salt.
„ Do not hose down the unit with water!
Water penetration may cause malfunctions (ignition
system, carburettor).
„ Replace the silencer if defective.
„ Follow the maintenance schedule.
„ Follow the instructions in the engine manual.
Maintenance schedule
Before each use
Check the oil level (see engine manual).
„
Check the shear pins.
„
Check machine for damage.
„
After the first 5 hours of operation
Change the engine oil (see engine ma-
„
nual).
Every three months
Check the tyre pressure.
„
Oil the ring of the snow discharge with
„
spray oil (
6).
Annually
Replace spark plug (see engine manual).
„
Lubricate auger.
„
Lubricating the auger
Using a grease gun, inject 2 to 3 shots of univer-
sal grease into the grease nipple (
474911_a
Maintaining the wheel drive
Adjusting the control cable
If the wheel drive no longer engages when the
engine is running, the control cable must be ad-
justed.
1. Loosen lock nut (
2. Turn the adjuster on the control cable in the
direction of the arrow (
trol cable no longer sags (is slightly tensi-
oned). Hold the cable while tightening so that
it does not twist.
3. Tighten the lock nut(
4. Check the adjustment by starting the engine
and engaging the wheel drive.
5. If the wheel drive still does not engage and
disengage properly, have the machine re-
paired by a qualified workshop.
Maintaining the auger drive
Adjusting the control cable
If the auger drive no longer engages when the
engine is running, the control cable must be ad-
justed.
1. Loosen lock nut (
2. Turn the adjuster on the control cable in the
direction of the arrow (
trol cable no longer sags (is slightly tensi-
oned). Hold the cable while tightening so that
it does not twist.
3. Tighten the lock nut(
31).
Caution!
▪ Switch off the engine before adjusting the
control cable.
▪ If the wheel drive mechanism cannot be
disengaged, switch off the engine. Do not
attempt repair; contact a qualified workshop.
2-1).
Caution!
▪ Switch off the engine before adjusting the
control cable.
▪ If the auger drive mechanism cannot be
disengaged, switch off the engine. Do not
attempt repair; contact a qualified workshop.
2-1).
GB
2-2) until the con-
2-1) firmly.
2-2) until the con-
2-1) firmly.
33