Aqua Marina 3014602 Mode D'emploi page 35

5. Apply the patch starting on one side and move towards the other side
Be careful not to trap any air bubbles.
6. Use a hairdryer to gently heat the area to ensure a good bond between
the patch and the board.
Use a metal spatula or spoon and firm pressure to ensure a good bond
and to remove any air bubbles.
HOW TO FIX A LEAKING VALVE
H
A. Try to tighten the valve
B. Re-install or replace a valve
1. Completely deflate your board
2. Undo the dust cap and insert the valve wrench into the valve and
twist counterclockwise to remove the valve
Allow the glue to cure with
24h
the board un-inflated for 24
hours prior to use.
1. Inflate your board up to the max air
pressure
2. Stick your valve wrench down inside of
valve and turn clockwise to tighten the
valve back down onto the board
15