Saving Energy; Changing The Program Mid-Cycle - Pando PLB-7160 Manuel D'installation

Saving Energy

1. Pre-rinsing of tableware items leads to increased water and energy consumption
and is not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is
used according to the instructions.
Starting A program
1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche".
Make sure that the water supply is turned on to full pressure.
4. Open the door, Press the Power button.
5. Choose a program, the response light will turn on. Then close the door, the
dishwasher will start its cycle.

Changing The Program Mid-cycle

A program can only be changed if it has been running only for a short period of
time, otherwise the detergent may have already been released or the the wash
water with detergent has already been drained. If this is the case, the dishwasher
needs to be reset and the detergent dispenser must be refilled. To reset the
dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stopped
working, you can open the door completely.
2. Press Program button more than three seconds the machine will be in
program selection mode.
3. You can change the program to the desired cycle setting.
3 sec
30