Setting Up Power Supply - Bresser 9686100 Mode D'emploi

NOTICE! Formatting means that all data on the memory
card will be irrevocably lost.
7. Press the MENU button to exit the menu.
8. Press and hold the ON / OFF button for 2 seconds to
switch off the device.
9. Disconnect the device from the power supply.

10 Setting up power supply

Power supply via USB cable
1. Insert the mini USB connector on the USB cable into
the USB connector socket on the camera.
2. Insert the USB-A connector on the cable into the empty
USB port on the computer. The computer provides the
power supply once it has been switched on. The blue
light appears on the camera.
NOTICE! Using a suitable USB network adapter*, the
USB cable can also be used to connect the camera to
mains power or to a power bank.* Simply insert the
USB-A connector into the corresponding connector
socket of the USB network adapter or power bank.
Power supply via in-car charger
3. Insert the mini USB connector on the in-car charger
into the USB connector socket on the camera
4. Insert the vehicle connector plug into the on-board
voltage connector (cigarette lighter). A direct power
supply is established. The blue function light appears.
*not included
37 / 92