mysoda TOBY Mode D'emploi page 6

TECHNICAL SPECIFICATIONS
Max. operating pressure: 10 bar/145 Psi
Max. operating temperature: 40°C/104°F
Bottle capacity: 1.0 L (33.8 oz.)
Max. filling volume of the bottle: 0.85L (28,7 oz)
Requires no electricity
Mysoda is a registered trademark of Mysoda Oy.
WARRANTY
We want to make sure that you enjoy your Mysoda sparkling water maker for a long
time. To ensure a complete user experience for you, our equipment has a twenty-
four (24) month warranty from the date of purchase. Our warranty is valid for
household use.
The warranty does NOT cover the following:
• Defects caused by carbonating other liquid than water.
• Wear and tear under normal consumer use (e.g. discoloration).
• Defects and damage resulting from the use of a water bottle after expiration
time.
• Defects and damage caused by a CO2 Cylinder used past its expiration date.
• Defects due to damage during transport and any abnormal household use.
• Defects due to the use of CO2 cylinders sold by non-authorized dealers.
• Defects due to improper use, modification or commercial use of the sparkling
water maker.
If your Mysoda device needs servicing, contact your local Mysoda retailer or contact
Mysoda directly by emailing us at info@mysoda.eu or visiting our website:
www.mysoda.eu.
mysoda.eu
10
TROUBLESHOOTING
ISSUE PROBABLE CAUSE
Water bottle can't be Quick lock is in wrong position
attached to the quick lock
Water bottle can't be Water bottle is in wrong position
released from the quick
lock
Water bottle overflows Bottle is overfilled
during the carbonation
Carbonating button is pressed too
long
Water is not well
CO2 cylinder is running low
carbonated/bubbly
enough
Water is too warm
CO2 cylinder is not screwed in tight
enough
CO2 cylinder leaks after CO2 cylinder is not screwed in tight
installation
130 litre cylinder can't be The bottom adapter is in the wrong
installed position
Small, white ice particles This is normal, especially when the
form around the nozzle water is cold
during the carbonation
Device makes a whistling This is normal and ends once the
noise during the carbonation is completed
carbonation
SOLUTION
Pull the quick lock and nozzle towards
yourself. Attach the bottle by turning
one quarter anti-clockwise
Gently pull the water bottle towards
yourself until it reaches its fully EN
forward tilt position. Release the bottle
by turning one quarter clockwise.
Fill the bottle with water up to the fill
line indicating the maximum level
Do not press the carbonating button
for longer than 1–2 seconds at a time
Replace the used CO2 cylinder with a
new one
Make sure the water used is as cold
as possible as CO2 dissolves better in
cold water
Screw the CO2 cylinder tightly into
the device
Remove the CO2 cylinder and reattach
it securely. Do it by hand, do not use
tools. Do not overtight.
Uninstall the bottom adapter and put it
back the other way round.
11