mysoda TOBY Mode D'emploi page 4

PARTS AND FEATURES
SPARKLING WATER MAKER
Carbonating button
Device top part
Carbonation nozzle
Device bottom part
Drip cover
CO2 CYLINDER
BEFORE THE FIRST USE: Hand-wash the water bottle with warm water and hand dishwashing
detergent. Rinse well and wipe outside with a soft cloth to dry. WARNING: Never wash water bottles in
a dishwasher or in hot water. Harsh chemicals will damage the water bottle.
6
1L WATER BOTTLE
Bottle cap
Max fill level
INSTALLING THE CO2 CYLINDER
NOTE: The device can use 60 litre and 130 litre CO2 cylinders. 130 litre cylinders are available on a
limited basis and only in certain countries.
1
1. Remove the water bottle 2. Uninstall the top part of
by pulling the bottle and the device body by turning
carbonation nozzle towards it anti-clockwise.
yourself, and then unscrew it
(one quarter clockwise).
Installing 60L CO2 cylinder:
1
5a. Install the CO2 cylinder by 6a. Carefully insert the CO2 cylinder
screwing it clockwise. Attach the and top part together to the bottom
cylinder firmly enough, but do not part. Turn the top part clockwise until
tighten too much. it clicks into place.
Installing 130L CO2 cylinder:
1
2
5b. Carefully insert the top part to 6b. If you are using a 130 litre CO2 cylinder, turn over the adapter on the
the bottom part. Turn the top part
bottom of the unit, so that you can install a larger cylinder.
clockwise until it clicks into place.
2
3. Unscrew the black 4. Remove the seal and cap
thread protective cap on from the CO2 cylinder.
the top part of the device
body.
CHANGING THE
CO2 CYLINDER:
2
After the CO2 cylinder is
empty, replace the CO2
cylinder in the same way as
the first time you installed
the cylinder.
EN
7