Changing The Light Bulb; Defrost; Troubleshooting - Summit SPR7OSST Série Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CHANGING THE LIGHT BULB

NOTE: Not all appliance bulbs will fit your appliance. Be sure to replace the bulb with one of the same
size, shape, base size and wattage. You can purchase bulbs at www.summitapplianceparts.com.
Unplug the appliance or disconnect power.
1.
Remove the light shield. Most models do not require tools.
2.
3.
Replace the light bulb with an appliance bulb of the same wattage.
4.
Replace the light shield.
Plug in the appliance or reconnect power.
5.

DEFROST

Defrosting takes place automatically.
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling a service technician.
PROBLEM
The unit does not operate.
The unit is not cold enough.
Turns on and off frequently.
The light does not work.
Vibrations
The unit seems to make too much noise.
The door will not close properly.
If you've checked the table above and find that you still need help with your appliance, call our Customer
800-932-4267
Service facility at
questions.

TROUBLESHOOTING

Not plugged in.
The appliance is turned off.
Tripped circuit breaker or blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The ambient temperature is warmer than normal.
A large amount of contents has been added to the unit.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Not plugged in.
Tripped circuit breaker or blown fuse.
The light switch is "OFF".
Check to assure that the appliance is level.
A rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your unit.
Contraction and expansion of the inside walls may cause
popping and crackling noises.
The appliance is not level.
The appliance is not level.
The door was reversed and not properly re-installed.
The gasket is dirty.
The shelves are out of position.
between 9:00AM and 5:00PM ET. We will do our best to answer your
9
POSSIBLE CAUSE

Publicité

Chapitres

Table des Matières
loading

Table des Matières