Publicité
Les langues disponibles
Les langues disponibles
4
SETUP
(ALL TREESTAND MODELS)
SEAT
Your foam seat must be attached to the climber platform
before use. The straps and buckles are attached and buckled
on the bottom of the seat from the factory. Please unbuckle
before proceeding.
1. Place your seat platform on a flat surface with the rear "V"
brace facing up.
2. Position the seat inside of the seat platform frame.
3. Wrap the seat strap webbing over the frame from the
inside out as shown in figure 1.
4. Turn the three bar slide slightly sideways and push it
through the metal D buckle that is sewn onto the end of the
strap (figure 2).
180 MAX SD
On the 180 Max SD the Surround Seat has three additional
snaps. These attach around the perimeter frame and the
upright arms to keep the sides of the seat in the correct
position.
RAPIDCLIMB STIRRUPS
Adjust the stirrups to fit your footwear at ground level. This
is done by loosening the wing-nut and sliding the stirrup up
or down the tube. Re-tighten the wing-nut once desired fit
is achieved. NEVER remove the wing-nut or stirrups. NEVER
slide the stirrup outside of the acceptable adjustment range
showed in figure 3 and 3b.
!
Moving your foot placement closer to the tree changes
the leverage needed to adhere the platform to the tree.
Attaching the stirrups or placing your feet too close to
the tree may cause the platform to slide down the tree
which could cause serious injury or death. See figure 3
and 3b for proper foot location.
RAZOR SD FRONT BAR USE
If you purchased a Razor SD, you must first position the climbing bar in order to sit on it and climb. Position the climbing bar
so that the keyhole slot in the support strut will fit over the head of the bolt as shown in figure 4. At the same time, slide both
support bars over the bolts and completely through the keyhole slots as shown in figure 5. Pull down on the climbing bar to
"seat" the bolts into the back of the support struts (See figure 6). The climbing bar is now ready to use.
4
WARNING
5
1
WARNING
!
Replace all seat cushions every two (2) years or
sooner if damage or wear is present.
NOTICE
The seat included with these treestands is removable
for storage. DO NOT leave your stand outdoors
when it is not being used.
3
2
ACCEPTABLE ADJUSTMENT RANGE
3b
6
PG 7
Publicité
