Summit Treestands Viper SD Mode D'emploi page 13

CLIMBING DOWN
WARNING
!
NEVER DISCONNECT FROM YOUR FBFAHS OR
SAFETY LINE ONCE YOU LEAVE THE GROUND!!
1. Reattach your foot platform to your feet. Back
your heel into the bungee heel cord (figure 24) then
slide your boot under the RapidClimb stirrup. Make
sure that your boot is secure under the stirrup as
shown in figure 25.
2. Disconnect the elastic cord that has been holding
the foam seat in place and fold the seat up. Secure
the backrest and seat as shown in figure 26.
Disconnect and store the strap that has held the seat
frame to the tree (figure 27).
3. Place the seat platform at about knee level, sit on
the padded bar (or in the seat on the 180 SD model),
and grasp the upright arms as you did when climbing
(see figure 28).
4. While firmly grasping the seat platform upright
arms, disengage the foot platform by lifting up and
tipping the edge closest to the tree downward. Once
the foot platform has been dislodged, you can lower
it down (see figure 29). Make slow, even movements
of 10 inches or less at a time.
5. To re-engage, rotate the top edge of the treestand
closest to the tree upwards. Now carefully place your
weight back on the foot platform.
6. Once the foot platform is secure, stand and slide
your FBFAHS tether strap down to about chest height
and repeat steps 3-6 until you have reached the
bottom of the tree.
Use short controlled movements when
ascending or descending the tree. NEVER
GET IN A HURRY! The FBFAHS must be
used from the time you leave the ground
until safely returning to the ground.
28
24
26
WARNING
!
25
27
29
PG 13