Summit Treestands Viper SD Mode D'emploi page 14

6
CLIMBING UP / USE / CLIMBING DOWN
CLIMBING UP WITH YOUR NEW STAND
WARNING
!
At this point IT IS MANDATORY AND REQUIRED
that you attach your FBFAHS to the tree and
remain connected at all times after leaving the
ground.
ALWAYS refer to the written FBFAHS instructions
and videos for proper and safe use of your FBFAHS
before climbing.
1. Following the FBFAHS Instructions, attach the
harness tether to the tether strap. Loop the strap
around the tree to secure it. See figure 30.
2. Your RapidClimb stirrups and bungee heel cord
should be already attached to your treestand. To use,
back your heel into the bungee heel cord (figure 31)
then simply slide your boot under the RapidClimb
stirrup. Make sure that your boot is secure under the
stirrup as shown in figure 32.
3. On the Cobra, hook the seat back elastic bungee
cord around the seat as shown in figure 33 to keep it
secure while you climb.
4. To begin climbing, raise your seat climber up to
just below waist height and grasp the upright arms
very firmly as shown in figure 34.
34
PG 14
30
32
(OPEN FRONT STANDS)
31
33
www.summitstands.com